DESIGN, FORMULATION AND IN VITRO DRUG RELEASE FROM TRANSDERMAL PATCHES CONTAINING IMIPRAMINE HYDROCHLORIDE AS MODEL DRUG

Authors

  • Swati Hardainiyan Department of Agriculture, Food and Biotechnology, Jayoti Vidyapeeth Women’s University, Jaipur, Rajasthan, 303122, India
  • Krishan Kumar Department of Agriculture, Food and Biotechnology, Jayoti Vidyapeeth Women’s University, Jaipur, Rajasthan, 303122, India
  • Bankim Chandra Nandy Department of Pharmaceutical Science, Jayoti Vidyapeeth Women’s University, Jaipur, Rajasthan, 303122, India
  • Richa Saxena Department of Agriculture, Food and Biotechnology, Jayoti Vidyapeeth Women’s University, Jaipur, Rajasthan, 303122, India

DOI:

https://doi.org/10.22159/ijpps.2017v9i6.16851

Keywords:

Imipramine Hydrochloride, Transdermal patch, PVP K-30, HPMC K100M, Solvent evaporation technique, In vitro skin permeation

Abstract

Objective: The aim of the present investigation was to form matrix type transdermal patches containing imipramine hydrochloride were prepared using two polymers by solvent evaporation technique to minimise the dose of the drug for lesser side effect and increase the bioavailability of a drug.

Methods: In the present study, drug loaded matrix type transdermal films of imipramine hydrochloride were prepared by the solvent evaporation method with the help of polymers along with polyethene glycol (PEG) 400 was used as plasticizer and dimethyl sulfoxide (DMSO) was used as penetration enhancer. Drug-polymer interactions determine by FTIR and a standard calibration curve of imipramine hydrochloride was determined by using UV estimation.

Results: The formulated transdermal patch by using PVP K-30, HPMC K100M showed good physical properties. All prepared formulations indicated good physical stability. The formulation F-1 gave the most suitable transdermal film with all desirable physicochemical properties. The thickness of the patches was varied from 0.263±0.67 mm to 0.301±0.61 mm, uniformity of patches showed that patches prepared by solvent evaporation while low standard deviation values ensued by thickness measurements of the film, and weights ranged between 50.5±0.75 mg and 52.15±2.15 mg, which indicates that different batches patch weights, were comparatively similar. Folding endurance was found to be>200 that is satisfactory for the patches, drug content was found to be 5.33±0.14 mg to 5.57±0.095 mg. In vitro, drug permeation studies of formulations were performed by using K-C diffusion cells using abdomen skin of the albino rat. The results were best in in-vitro skin permeation through rat skin as compared to all other formulations prepared with a hydrophilic polymer containing permeation enhancer. The formulation, F1 is considered as the best formulation, since it shows maximum in vitro drug release as 84.71±3.07 % at 24 h. The drug release kinetics studies showed that the majority of formulations were governed by Higuchi model and mechanism of release was non-Fickian mediated.

Conclusion: In conclusion, controlled release transdermal drug delivery system (TDDS) patches of imipramine hydrochloride can be prepared using the polymer combinations, with plasticizer and enhancer. The release rate of drug through patched increased simultaneously as the concentration of hydrophilic polymer was increased. However, the mechanism of drug release of all formulations was non-Fickian. The properties of a film did not change during the period of study.

Downloads

Download data is not yet available.

References

Kumar JA, Pullakandan N, Prabu SL, Gopal V. Transdermal drug delivery system: an overview. Int J Pharm Sci Rev Res 2010;3:49-53.

Singh JV, Singh SJ, Sharma AK, Gilhotra RM, Sharma A, Jat RK. Design, formulation and in vitro drug release from transdermal patches containing Nebivolol hydrochloride as model drug. Asian J Pharm Res 2012;2:136-41.

Kooriyattil N, Sajeeth CI, Santhi K. Formulation, optimization and evaluation of matrix-type of transdermal system of simvastatin using permeation enhancers. Int J Curr Pharm Res 2012;4:79-87.

Latha S, Selvamani P, Thirunavukkarasu C, kadambavadani R. Formulation development and comparison in the evaluation of a transdermal drugs delivery system for anti-emetic therapy. Int J Res Pharm Biomed Sci 2011;2:525-8.

Costa P, Ferreria DC, Morgado R, Sousa Lobo JM. Design and evaluation of the alorazepam transdermal delivery system. Drug Dev Ind Pharm 1997;23:939-44.

Hardman JG, Limbird LE, Goodman Gilman A. Goodman and Gilmans: The Pharmacological Basis of Therapeutics. 10th ed. New York: The McGraw Hill Companies; 2001. p. 399-428, 450-77.

Reddy G, Ramesh C, Narayana T, Rao K, Rao B. Development of ion-association methods for spectrophotometric assay of imipramine hydrochloride. Int J Chem Sci 2011;9:457-64.

Maj J, Miroslawa M, Ewa M, Wladyslawa D. Different pharmacokinetic and pharmacological effects following acute and chronic treatment with imipramine. J Neu Trans 1982;54:219-28.

Jainy AK, Panchagnula R. Transdermal delivery of imipramine hydrochloride: development and evaluation (in vitro and in vivo) of reservoir gel formulation. Biopharm Drug Dispos 2005;26:41-9.

Stott PW, Williams AC, Barry BW. Characterization of complex coacervates of some tricyclic antidepressants and evaluation of their potential for enhancing transdermal flux. J Controlled Release 1996;41:215-27.

Sivakumar T, Selvam PR, Singh AK. Transdermal drug delivery systems for antihypertensive drugs-a review. Int J Pharm Biomed Res 2010;1:1-8.

Kaur T, Gill B, Kumar S, Gupta GD. Design and development of hydroxypropyl methycellulose (HPMC) based polymeric films of sertraline hydrochloride: physicochemical, in vitro and in vivo evaluation. Innovations Pharm Pharmacother 2013;1:103-16.

Gupta JRD, Tripathi P, Irchhiaya R, Garud N, Dubey P, Patel JR. Formulation and evaluation of matrix type transdermal patches of glibenclamide. Int J Pharm Sci Drug Res 2009;1:46-50.

Devi VK, Saisivam S, Maria GR, Deepti PU. Design and evaluation of matrix diffusion controlled transdermal patches of verapamil hydrochloride. Drug Dev Ind Pharm 2003;29:495-503.

Mutalik S, Udupa N. Glibenclamide transdermal patches: physicochemical, pharmacodynamic, and pharmacokinetic evaluations. Pharma Sci 2004;93:1577-94.

Shinde AJ, Garala KC, More HN. Development and characterization of transdermal therapeutics system of tramadol hydrochloride. Asian J Pharm 2008;2:265-9.

Mathews BR. Regulatory aspects of stability testing in Europe. Drug Dev Ind Pharm 1999;25:831-56.

Chien YW. Controlled drug delivery fundamentals and application. 2nd Ed. Robinson JR, Lee VHL. Eds. Marcel Dekker, Inc. New York; 1987. p. 39-55.

Jadhav SB, Mali AD, Rajeghadage SH, Bathe RS. Formulation and evaluation of immediate release tablets of imipramine hydrochloride. Int J Biomed Adv Res 2014;5:559-65.

Akbuga J, Bergisadi N. Effect of drug properties on physical and release characteristics of eudragit microspheres prepared by spherical crystallization technique. Drug Dev Ind Pharm 1997;23:407-41.

Bosca MMT, Hinojosa OJ, Claramonte CMD, Salem II. Statistical comparison of two methods of dissolution of sustained-release theophylline tablets. Drug Dev Ind Pharm 1996;22:595-60.

Siepmann J, Peppas NA. Modeling of drug release from delivery systems based on hydroxypropyl methylcellulose (HPMC). Adv Drug Delivery Rev 2001;48:139–57.

Zuleger S, Lippold BC. Polymer particle erosion controlling drug release. I. Factors influencing drug release and characterization of the release mechanism. Int J Pharm 2001;217:139–52.

Published

01-06-2017

How to Cite

Hardainiyan, S., K. Kumar, B. C. Nandy, and R. Saxena. “DESIGN, FORMULATION AND IN VITRO DRUG RELEASE FROM TRANSDERMAL PATCHES CONTAINING IMIPRAMINE HYDROCHLORIDE AS MODEL DRUG”. International Journal of Pharmacy and Pharmaceutical Sciences, vol. 9, no. 6, June 2017, pp. 220-5, doi:10.22159/ijpps.2017v9i6.16851.

Issue

Section

Innopharm 2 Conference Proceeding